| MONTEST-LCD Connector Pin Signal Assignments |
| Output Signal |
Connector Pins |
| MAC II |
SUN |
VGA |
BNC |
| Red |
2 |
A1 |
1 |
Red |
| Green |
5 |
A2 |
2 |
Green |
| Blue |
9 |
A3 |
3 |
Blue |
| Horizontal/Composite |
15 |
6 |
13 |
Horiz |
| Verticle |
12 |
2 |
14 |
Vert |
| Composite Sync |
4 |
5 |
---- |
---- |
| Ground |
1,6,11,13,14 |
1,4,7,10 |
4,5,6,7,8,10,11 |
Shell |
Note: When composite sync is selected, the composite sync is available on both the Horizontal/Composite and the Composite Sync outputs.
| Sync Type |
Cables |
Connection |
| Sync On Green |
3 |
Red, Green, Blue |
| Composite |
4 |
Red, Green, Blue, Horizontal/Composite |
| Horizontal & Verticle |
5 |
Red, Green, Blue Horizontal/Composite, Verticle |
|
- Outputs are:
- RGB=700mVpp(terminated into 75 ohms).
- Sync on Green= -300mV.
- Horizontal, Verticle & Composite=TTL levels
- All outputs are protected and limited to .7 to +5.7 volts.
- Connect only one output at a time. The output signals wire to the connectors in parallel. Connecting multiple outputs simultaneously will reduce the output signal level with multiple terminations.
- Output connections to the monitor:
- A common PC monitor connects to the VGA (15 pin HD) or the MAC II (15 pin D) connectors.
- A Sun monitor is connected to the Sun (13W3 D) connector. Other monitors with a 13W3 type connector may have a different pin out. Consult the monitor's manual for the monitor pin-out. Those monitors with a different pin-out should be connected with an adapter.
- A monitor with BNC connectors or an adapter cable can be connected to the BNC connectors on the Montest-LCD. The number of required connections will vary with the type of sync used.
|
Montest-LCD 
